Agilent Technologies U1840A Medalist sj5000 Hardware Manual page 129

Agilent U1840A Medalist sj5000 Hardware Manual
This will download the setup file to the barcode reader. The
reader will emit a beep to indicate the download was
successful.
8
Remove the barcode reader from the XP-40 port and replace
with the slave barcode reader.
Click Auto connect to communicate with the barcode reader.
9
Click File > Open to open the setup file 820DL01.esp.
10
Click Send/Recv > Send to Reader > Send and Save to save this
11
to slave barcode reader.
12
Plug the master barcode reader to the XP-40 port and the
slave barcode reader to the XP-41 port on the breakout box.
To test both barcode readers, click Terminal.
13
Click Enable Serial Trigger > Send Trigger Character.
a
(Alternatively, trigger the conveyor entry sensor.)
b
Scan a barcode with the master barcode reader and the
decoded barcode text should be displayed with a 00
prefix.
c
Scan a barcode with the slave barcode reader and the
decoded barcode text should be displayed with a 01
prefix. Note that it will be displayed only when the master
barcode reader times out.
14
Close the ESP software and launch the sj5000 software.
Setting Up Barcode Readers
10
10-13