Intended Use; Cleaning/Recycling The Product; Accidental Liquid Spillage; Moving Or Storing The Msd - Agilent Technologies 5975 Series Operating Manual

1 Introduction

Intended Use

Agilent products must be used only in the manner described in the Agilent
product user guides. Any other use may result in damage to the product or
personal injury. Agilent is not responsible for any damages caused, in whole or in
part, by improper use of the products, unauthorized alterations, adjustments, or
modifications to the products, failure to comply with procedures in Agilent
product user guides, or use of the products in violation of applicable laws, rules,
or regulations.

Cleaning/Recycling the Product

To clean the unit, disconnect the power and wipe down with a damp, lint-free
cloth. For recycling, contact your local Agilent sales office.

Accidental Liquid Spillage

Do not spill liquids on the MSD. If liquid is accidentally spilled on the MSD, first,
cut the power. Once the MSD is disconnected from all power sources, dry all
affected parts. If the liquid spillage affects the electronics, wait at least 24 hours,
depending upon the ambient humidity. While waiting for the parts to dry, please
call your local Agilent service representative.

Moving or Storing the MSD

The best way to keep your MSD functioning properly is to keep it pumped down
and hot, with carrier gas flow. If you plan to move or store your MSD, additional
precautions are required:
•
•
26
The MSD must remain upright at all times; this requires special caution when
moving.
The MSD should not be left vented to atmosphere for long periods.
5975/5977 Series MSD Operating Manual