Parts Of The Medalist Sj5000 - Agilent Technologies U1840A Medalist sj5000 Hardware Manual

Parts of the Medalist sj5000

System Overview
Agilent U1840A Medalist sj5000 Hardware Manual
The Medalist sj5000 (Figure
welded base frame which gives stability and support to the XY
gantry robot and houses the electrical controls of the machine.
• The PC is behind the front access door.
• The gantry motor amplifiers are located at the rear of the
system in the control panel. The standard sj5000 has two
amplifiers for the X and Y axes.
• Connections for two SMEMA cables and an Ethernet cable
are provided at the rear of the system. These are located on
the right side of the control panel.
• The electrical mains inlet cable is supplied through a cut-out
in the machine base-plate, which is accessible from the
control panel.
Figure 2-1 Medalist sj5000
Introduction to the Medalist sj5000
2-1) is constructed from a rigid
2
2-5