Program the Barcode Reader
Agilent U1840A Medalist sj5000 Hardware Manual
number in the Device Manager (see
Port Number in Device
e
Exit the editor and restart the PC.
Checking the Serial Port Number in Device Manager
To find out the serial port number:
1
Make sure the barcode reader is connected.
Open the Device Manager by clicking Start > Control Panel >
2
System > Hardware > Device Manager.
3
Look under Ports to find the USB-to-Serial port as shown
below.
To program the barcode reader, refer to the Datalogic DLC7000
Series Manual. Then do the following:
• Scan the barcodes Restore Defaults, RS232, and English from the
manual with the reader. After each scan the reader should
emit two audible beeps.
• Next scan Code 39. When Code 39 is scanned the reader
should only beep once.
Setting Up Barcode Readers
"Checking the Serial
Manager").
10
10-17