Agilent Technologies U1840A Medalist sj5000 Hardware Manual page 11

Safety Requirements
Machine's Intended Use
C A U T I O N
Agilent U1840A Medalist sj5000 Hardware Manual
Verify there are multiple and sufficient protective means (rated
for the voltages you are applying) to assure the operator will
NOT come into contact with any energized conductor even if
one of the protective means fails to work as intended. For
example, the inner side of a case, cabinet, door cover or panel
can be covered with an insulating material as well as routing the
test cables to the front panel connectors of the module through
non-conductive, flexible conduit such as that used in electrical
power distribution.
The following is a list of the safety requirements for electrical
equipment for measurement control and laboratory use:
• IEC 61010-1:2001 / EN 61010-1:2001
• Canada: CSA- C22.2 No.1010.1:1992
• USA: UL 61010A-1 :2002
See certificate for list of relevant standards.
In addition with the above environmental conditions, the
machine is designed to be used solely in a Surface Mount
Technologies (SMT) production line.
This machine must only be used with conveyors on both sides
either in-line or in off-line operation. This is to prevent users from
accessing pinch points inside the machine.
Safety and Regulatory Information
1
1-5