Agilent Technologies U1840A Medalist sj5000 Hardware Manual page 60

5
Changing the Conveyor Rail Width
Auto Width Adjust
The Auto Width Adjust Window
5-4
You can manually adjust the distance between the conveyor
rails using the sj5000 software.
1
Ensure there are no boards in the sj5000.
2
Launch the sj5000 software in Engineer mode.
In the main toolbar click the Tools button.
3
Under Category, click the Auto Width Adjust folder.
4
5
You will be reminded to remove all boards from the sj5000.
Click Yes to continue. (You will not be able to continue if any
boards remain in the machine.)
6
In the Auto Width Adjust window
Out and Jog In buttons to adjust the distance between the
conveyor rails.
To access the Auto Width Adjust tools, from the Tools menu
click the Auto Width Adjust folder.
Figure 5-3 Auto Width Adjust window
Table 5-1 Tools for Auto Width Adjust
Field/Function Description
Min Width Displays the minimum conveyor width allowed. If you enter
a Required Width that is less than the minimum, then this
value will be used instead.
Max Width Displays the maximum conveyor width allowed. If you
enter a Required Width that is greater than the maximum,
then this value will be used instead.
(Figure
Agilent U1840A Medalist sj5000 Hardware Manual
5-3), click the Jog