Agilent Technologies U1840A Medalist sj5000 Hardware Manual page 131

Handheld Barcode Reader
Install the Barcode Reader
Agilent U1840A Medalist sj5000 Hardware Manual
Handheld Barcode reader
5186-2218
5V power cable
5186-xxxx
1
Connect the gray communications cable to the handheld
barcode reader, and connect the other end to the blue
USB-to-Serial Converter cable.
2
Connect the blue USB connector to one of the USB ports on
the PC.
3
Plug the 5 V power cable into the RS232 connector of the
handheld barcode reader. Plug the other end into a free USB
port on the PC.
The barcode reader will flash on and off, and then emit three
beeps.
4
Install the USB-to-Serial driver:
a
Insert the Trendnet TU-S9 Software Installation CD into
the drive.
b
Browse to the \Driver\Win98_2003 folder and
double-click the Setup file. Follow the instructions on the
screen to complete the installation.
5
Once the installation is completed, connect the blue
converter cable to a free USB port on the PC.
6
Open the file c:\cpi\data\config.txt and check that it
contains the following line:
Barcode 1 0 1
Setting Up Barcode Readers
Grey RS232 Comm Cable
5186-2186
USB to Serial Converter
5186-xxxx
10
10-15