Agilent Technologies U1840A Medalist sj5000 Hardware Manual page 156

11
Troubleshooting
11-22
10
Make sure that the cable marked Halls/End highlighted below
is connected to C2 on the Kollmorgen drive. This cable gives
feedback on the 'Halls' and also on the gantry as it moves
along the encoder strip. Again, both drives should have this
cable.
11
At the back of the PC, check that a SyncNet cable (p/n
5186-6319) is correctly connected to the top LAN-type
connector on the motion controller card as shown below.
Agilent U1840A Medalist sj5000 Hardware Manual
Cable 5186-6319
connected to
top LAN-type
connector