Agilent Technologies U1840A Medalist sj5000 Hardware Manual page 170

11
Troubleshooting
11-36
8
Do the same for Axis 1. To have the axis move back and
forward continuously, select the Enabled option for Repeat
Mode and than click Move to Further.
9
If the axes are moving, it means the system is ready for
inspection. Disable the Repeat Mode, disable the motors
(disable Amp Enable in the Motor Summary window), and
close the MoCon window.
Mapping the Axes
1
On the MoCon toolbar, click the Object Controller button (to
the left of the C button).
Open the Controller 0 folder, then the Motion Supervisors and
2
Axes subfolders.
Agilent U1840A Medalist sj5000 Hardware Manual