Table of Contents
Advertisement
FusionModule2000-S Smart Modular Data Center
User Manual
Step 2 Install the mounting plate with the camera at the top of the front door of the end
cabinet, as shown in
Figure 3-100 Installing the camera mounting plate
Step 3 Connect the camera monitoring cable. Connect one end of a network cable to the
Ethernet port on the camera and the other end to any network port on the smart
ETH gateway (with PoE power supply).
Device cables not mentioned in the document do not need to be connected onsite
and should be insulated only.
Step 4 Adjust the monitoring image, as shown in
1.
2.
3.
Issue 03 (2021-07-15)
Figure
NO TICE
Determine an appropriate installation angle and set the aperture mode to
manual in image configuration.
Power on the ECC800-Pro to energize the camera.
Assign one person to log in to the camera control software to observe the
image on the monitor, and another person to adjust the camera to cover the
area to be monitored.
Copyright © Huawei Technologies Co., Ltd.
3-100.
Figure
3 Hardware Installation
3-101.
86
Advertisement
Table of Contents
