Table of Contents
Advertisement
FusionModule2000-S Smart Modular Data Center
User Manual
----End
5.3.12.4 Commissioning a Camera (Smart ETH Gateway Networking
Scenario)
5.3.12.4.1 Commissioning a C3220 Camera
Prerequisites
●
●
●
Context
●
●
●
●
Issue 03 (2021-07-15)
Figure 5-34 Setting the alarm linkage policy
If multiple cameras are connected, commission one camera first and then
commission other cameras in the same way.
The camera has connected to the smart ETH gateway and the smart ETH
gateway communicates properly with the ECC800-Pro.
The camera software version is later than SDC 8.0.RC111.
Before commissioning the C3220 camera, set the IP address for the C3220
camera based on customer requirements.
Configure the internal IP addresses of the camera and IVS1800 and the IP
address of the LAN port on the ECC800-Pro in the same network segment.
Configure the external IP addresses of the camera and IVS1800 and the IP
address of the WAN1 port on the ECC800-Pro in the same network.
Set the internal and external IP addresses as planned by the customer. The
following IP addresses are for reference only.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
185
Advertisement
Table of Contents
