Table of Contents
Advertisement
FusionModule2000-S Smart Modular Data Center
User Manual
screw inside each of the two vertical plates to ensure equipotential bonding with
the cabinet.
Figure 3-37 Installing the other vertical plate
Step 4 Press a supporting plate along the two vertical plates down to the place between
the four clasps and the cable bridge. Ensure that the supporting plate is fully into
the clasps.
When installing the supporting plate, do not remove the grommet strip on the U-shaped trough.
Figure 3-38 Installing a supporting plate
Step 5 Install a partition plate. Press both sides of the V-shaped partition plate with both
hands to decrease the angle to a proper degree, and clamp the clasps at the
bottom into the nearby holes.
Issue 03 (2021-07-15)
NO TE
Copyright © Huawei Technologies Co., Ltd.
3 Hardware Installation
53
Advertisement
Table of Contents
