Installing An Nmw - Huawei FusionModule2000-S User Manual

FusionModule2000-S Smart Modular Data Center
User Manual
Figure 3-47 Layout diagram
(1) General input unit
Figure 3-48 Cabling diagram

3.9.3.3 Installing an NMW

Prerequisites
Install the NMW from the first IT cabinet at the end of a row.
Procedure
Step 1 After determining the position for installing the first support, use a laser locator to
locate the positions of other supports. Ensure that they are arranged neatly.
Step 2 Secure the supports.
● The following procedure describes how to install a low support that applies to
● If there are bolts in the holes for securing the supports, remove the bolts and
● If the cabinet edges are uneven, secure the supports to the higher cabinet edge
Issue 03 (2021-07-15)
NO TICE
the cabinet front door scenario.
then secure the supports.
and use a level to ensure that the adjacent supports are flush in the front and
rear directions.
Copyright © Huawei Technologies Co., Ltd.
(2) Power distribution unit
3 Hardware Installation
(3) Aisle containment
60