FusionModule2000-S Smart Modular Data Center
User Manual
2.
3.
Step 2 Install cables at a round connector.
1.
2.
3.
4.
5.
6.
7.
8.
Issue 03 (2021-07-15)
Crimp a cord end terminal.
Figure 7-6 Crimping a cord end terminal
(1) Cord end terminal
(Optional) For a three-core cable with a cross-sectional area of 6 mm
the cable with two layers of heat shrink tubing and use a heat gun to heat-
shrink the tubing.
Figure 7-7 Crimping a cord end terminal
(1) Heat shrink tubing with
adhesive
Remove the rear cover from the round connector.
Loosen the screw on the cable clip.
Route the cables through the rear cover.
Insert cables into the round connector.
Tighten the screws to secure each cable.
Reinstall the rear cover.
(Optional) Seal the holes where no cables are installed.
Tighten the screw on the cable clip to the required torque. Gaps are allowed
on both sides of the cable clip.
Copyright © Huawei Technologies Co., Ltd.
(2) Cable
(2) Cable
7 Appendix
(3) Crimping tool
2
, wrap
(3) Heat gun
271