Table of Contents
Advertisement
FusionModule2000-S Smart Modular Data Center
User Manual
4G Networking
4G communication can be used to access the NetEco management system that
has a public IP address.
Step 1 Loosen the screws on both sides of the panel of the ECC800-Pro main control
module.
Step 2 Pull the handles on both sides of the panel of the ECC800-Pro main control
module, and remove the module.
Figure 5-65 Removing the ECC800-Pro main control module
Step 3 Install the SIM card.
Figure 5-66 Installing a SIM card
Step 4 Insert the ECC800-Pro main control module into the slot.
Step 5 Tighten the screws on both sides of the panel of the ECC800-Pro main control
module.
Step 6 Install a 4G antenna.
Issue 03 (2021-07-15)
NO TE
The monthly traffic of the SIM card is not less than the total traffic of all networked
devices. It is recommended that the monthly traffic of the SIM card be greater than or
equal to the total number of networked devices multiplied by 20 MB.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
209
Advertisement
Table of Contents
