I/O Carrier Module; Shunt Calibration Connector; Bridge Completion Circuits - MTS Systems FlexTest IIm Manual

I/O Carrier Module

Shunt calibration
connector
Bridge completion
circuits
MTS 793 Controller Hardware
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The I/O Carrier module has a shunt calibration connector on its front
panel that allows up to four shunt resistors (1 per slot) to be plugged
in. The SHUNT CAL connector is labeled to indicate which slot the
shunt calibration resistor is tied to.
Each shunt calibration resistor is soldered to a 2-pin holder (MTS PN
011-433-826). This holder plugs into the front panel connector shown
below. Refer to the 493.40/41 Carrier I/O Shunt Calibration Kit (MTS
PN 100-028-185) for more detailed information on kit components and
installation.
Each of the four I/O option card slots on the I/O Carrier module
provides support for up to three bridge completion resistors as well as
a shunt calibration resistor. The bridge completion resistors can be
installed into sockets on the I/O Carrier printed wiring board. The
shunt calibration resistor sockets are accessible from the I/O Carrier
front panel.
The following figures show three typical bridge configurations for a
DC conditioner installed on an I/O Carrier module.
FlexTest GT Controller Connections 93