Sensor Cables With Id Module; Shunt Calibration/Bridge Completion Resistor Installation - MTS Systems FlexTest IIm Manual

Sensor cables with ID
Module
C D
ABLE ESCRIPTION
ADT 120º
300º
Extensometer 633 capacitive
Force Transducer w/PT connector
w/PC connector
w/MS connector
LVDT
Δ
P control
Pressure Control (Sensotec)
Strain w/Amphenol connector
w/PT connector
Temposonics
Temposonics II (low power conditioner)
RVDT w/MS connector
* -XX specifies cable length. –01 through –09 represent 10–50 ft. in 5 ft. increments. Higher
numbers represent custom cable lengths

Shunt Calibration/Bridge Completion Resistor Installation

92
FlexTest GT Controller Connections
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
See the System Cable/Jumper Plug 493 Package Selection drawing (PN
700-000-656) for the most sensor cable current part numbers.
Each sensor includes a cable with an ID module built into it. Use a
system cable to bridge the sensor cable to the rear panel of the
controller chassis.
Sensor Cables and Connectors (ID Module)
ID M
ODULE W
052-543-5XX
052-443-6XX
052-543-4XX
052-542-5XX
052-542-6XX
052-542-7XX
052-543-1XX
052-543-2XX
052-543-3XX
052-542-9XX
052-543-0XX
052-543-7XX
052-543-8XX
052-750-8XX
.
On a typical system, shunt calibration and bridge completion resistor
installation is completed on the I/O Carrier module.
If you have purchased optional sensor cables with transducer ID
modules, shunt calibration and bridge resistors are installed on these
modules.
/C *
ABLE
S C
YSTEM ABLE
056-125-8XX
056-125-9XX
052-544-3XX
052-544-2XX
052-544-2XX
052-544-2XX
052-544-2XX
052-544-2XX
052-544-2XX
052-544-2XX
052-544-2XX
056-126-0XX
052-544-7XX
052-544-2XX
MTS 793 Controller Hardware
M
ODULE
C
ONNECTOR
493.40 J4–J7
493.40 J4–J7
493.40 J4–J7
493.40 J4–J7
493.40 J4–J7
493.40 J4–J7
493.40 J4–J7
493.40 J4–J7
493.40 J4–J7
493.40 J4–J7
493.40 J4–J7
493.40 J4–J7
493.40 J4–J7
493.40 J4–J7