Dräger Perseus A500 Instructions For Use Manual page 240

Technical data
Operating characteristics (continued)
Inrush current (ceiling-mounted version)
Without isolation transformer
Internal battery
Type
Capacity
Voltage
Fuse
Current
Backup time with new and fully charged bat-
tery
Minimum
Typical
Charging time (to reach full power)
Charging power
Gas supply
Gas quality
Oil content
Dew point
Particle size
Supply pressure for O
Maximum short-term peak inlet flows at
6.9 kPa x 100 (100 psi or 0.69 MPa) supply
pressure
O
2
Air
Without suction unit
Including a directly connected Dräger
ejector suction unit
N O
2
Drive gas
240
, Air, N O
2 2
Approx. 8 to 14 A peak
Approx. 6 to 10 A quasi-RMS
Lead-gel battery
Sealed, maintenance-free
7.2 Ah
24 V
F15A 80V UL248-14, breaking capacity 1000 A,
size 19.7 mm * 19 mm * 5 mm
Maximum 15 A
30 minutes
150 minutes
At least 8 hours
Max. 50 W
<0.1 mg/m3
5 °C (41 °F) at ambient temperature
Dust-free air (filtered with pore size <1 μm)
2.7 to 6.9 kPa x 100
39 to 100 psi
0.27 to 0.69 MPa
135 L/min (applies only when there is no distri-
bution piece for the central O
50 L/min
130 L/min
40 L/min
Not needed
Instructions for use Perseus A500 SW 2.0n
supply)
2