Dräger Perseus A500 Instructions For Use Manual page 211

Priority Alarm
!!! 0 Therapy settings not
applied
!! 100 Third agent detected
!! 30 Tidal volume not achieved The delivered inspiratory tidal
!!! 100 TurboVent 2 failure
!!! 100 TurboVent 2 not connected The TurboVent 2 blower mod-
!!! 100 Unknown alarm
! 0 USB write error
! 100 Vapor View failure (left slot) Failure of Vapor View hard-
! 100 Vapor View failure (middle
slot)
! 100 Vapor View failure (right
slot)
Instructions for use Perseus A500 SW 2.0n
Cause
The last changes to the ther-
apy settings were not applied.
A mixture of more than 2
anesthetic agents has been
detected.
There is electromagnetic
interference.
volume is lower than the set
value.
The TurboVent 2 blower mod-
ule is not operational or over-
heated.
ule is not connected.
Error in the internal alarm
system.
The USB flash drive is full,
faulty, write-protected, or not
compatible. The USB flash
drive is not correctly con-
nected. The USB flash drive
is not correctly formatted.
ware.
Failure of Vapor View hard-
ware.
Failure of Vapor View hard-
ware.
Troubleshooting
Remedy
Change to Man/Spon and
restart the ventilation mode.
Use "ALARM RESET" to
acknowledge alarm.
If the problem persists, call
DrägerService.
Flush the system if neces-
sary.
Check fresh-gas settings.
Wait for transition phase to
end.
Check for electromagnetic
radiation in the vicinity.
Check ventilation settings.
Check Pmax setting.
Check patient compliance.
Check if the patient is breath-
ing spontaneously.
Start manual ventilation!
Replace TurboVent 2 blower
module.
Insert the TurboVent 2 blower
module.
Use "ALARM RESET" to
downgrade alarm priority.
Check patient condition.
Call DrägerService.
Check the USB flash drive.
Use "ALARM RESET" to
acknowledge alarm.
If the problem persists, call
DrägerService.
Use "ALARM RESET" to
acknowledge alarm.
If the problem persists, call
DrägerService.
Use "ALARM RESET" to
acknowledge alarm.
If the problem persists, call
DrägerService.
Use "ALARM RESET" to
acknowledge alarm.
211