Connecting A Non-Rebreathing System (Optional) - Dräger Perseus A500 Instructions For Use Manual

Assembly and preparation
Connecting a non-rebreathing system
(optional)
This connection is only possible with the External
fresh-gas outlet option.
WARNING
Insufficient gas supply to the patient
Non-rebreathing systems are only suitable
and intended for manual ventilation or
spontaneous breathing and may only be
connected to the external fresh-gas outlet.
When using a non-rebreathing system,
ensure an adequate gas monitoring.
WARNING
Risk of excessively high airway pressure
Without a pressure-relief valve or breathing
bag, airway pressure may become too high.
Only connect breathing systems with
breathing bags or pressure-relief valves
which comply with ISO 8835-2.
Strictly follow the instructions for use for the non-
rebreathing system and the transfer hose.
To prevent contaminating the ambient air, connect
the gas outlet of the breathing system with the inlet
on the AGS. Use transfer hose with overpressure
valve complying with ISO 8835-3.
WARNING
Risk of faulty gas delivery
O and CO and any anesthetic gases must
2 2
also be monitored for non-rebreathing
systems.
The sample line must be connected to the
elbow and the water trap on the anesthesia
machine.
74
B
1 Tightly screw the sample line to the elbow of
the non-rebreathing system and water trap (A).
For elbows without port for sample line:
 Fit the T-piece with T-piece filter directly to
the elbow and tightly screw the sample line
to the T-piece filter. The part numbers for
the T-piece and the T-piece filter are listed
in the list of accessories.
Or
 If necessary, use the gas sampling port of
the filter on the Y-piece.
Ensure the correct course of the sample
line. Do not use adapters.
2 Connect the fresh-gas hose of the non-
rebreathing system to the external fresh-gas
outlet (B).
Instructions for use Perseus A500 SW 2.0n
A