Figure 2.4-2 - Esp6000 Controller Card Insertion Orientation; Figure 2.4-3 - Controller Card Device Driver Prompt (Representative Screen Only) - Newport ESP6000 User Manual

Section 2 — System Set-Up
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
N97114A
Figure 2.4-2 — ESP6000 Controller Card Insertion Orientation
Push down gently until the edge connector on the bottom of the ESP6000
card mates with the connector at the bottom of the computer chassis.
Install the retaining screw into the bracket at the top of the ESP6000 card.
Re-attach the enclosure and plug in the computer AC power cord.
Turn on the computer. If the ESP6000 card is installed properly, the front
LED (1) at the top of the card should illuminate red continuously. Refer to
Equipment Controls and Indicators, paragraph 2.3 of this section for
detailed LED information.
After booting-up, a Windows 95 system will respond to the ESP6000 card
installation with the following prompt (see Figure 2.4-3)
NEW HARDWARE FOUND
Select Which Driver You Want To Install For Your Hardware:
Windows Default Driver
Driver From Disk Provided By Hardware Manufacturer
Do Not Install A Driver (Windows will Not Prompt You Again)
Select From A List Of Alternate Drivers
Figure 2.4-3 — Controller Card Device Driver Prompt
(Representative Screen Only)
OK CANCEL HELP
2 - 7