Optional Power Supply Connector; Table C.3-4 - Optional Power Supply Connector Pin-Outs - Newport ESP6000 User Manual

C - 2 6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Fault_1 - _6
This Amplifier Fault input is pulled-up to +5 volts with a 1KΩ resistor by
the controller. The state of this signal is controlled by the motor driver
and monitored by the controller.
ESP_DAC_1 - 6
ESP_DAC is the controller's servo control, ±10 volt analog signal output.
AGND
Servo digital-to-analog converter (DAC) ground.
C.3.3 Optional Power Supply Connector
This connector is used for to provide an external supply power for stage
home, limit, and encoder circuits. Connector pin-outs are listed in Table
C.3-4, and functionally described in the following paragraphs.
Table C.3-4 — Optional Power Supply Connector Pin-Outs
+12V
+12 volt supply.
+5V
+5 volt supply.
–12V
–12 volt supply.
AGND
Analog ground.
DGND
Digital ground.
J8 Pins Function
1 +5V
2 DGND
3 –12V
4 +12V
5 AGND