Section 8 - Optional Equipment; Esp6000 Controller Card; Terminal Block Board; Table 8-1 - Optional Equipment - Newport ESP6000 User Manual

Section 8
Optional Equipment
8.1

ESP6000 Controller Card

Section 8 — Optional Equipment
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Options for the ESP6000 controller card consist of a terminal block board,
three utility interface cables, and the 100-to-100 and 100-to-68 pin interface
cables which connect to the UniDrive and Universal Interface Box (UIB),
respectively. Each utility interface cable plugs into a connector on the
controller card and has an integral faceplate for attaching to an individual
PC slot. Optional equipment for the UniDrive6000 universal motor driver
consists of motor driver card(s) and rack-mount ears.
Refer to paragraph 8.2 for motor driver card and rack-mount ear installation.
Optional equipment is listed in Table 8-1, and described in the following
paragraphs. Refer to Appendix G, Factory Service for ordering information.
Description

Terminal Block Board

Analog I/O Cable
Digital I/O Cable
Auxiliary Cable
Driver Interface (100-100 pin) Cable
Motor/Driver Interface (100-68 pin) Cable
Motor Driver Card
Rack-Mount Option
Verify proper alignment before inserting cables into connectors.
8.1.1 Terminal Block Board
The main (100-pin) connector of the ESP6000 controller card is intended to
directly attach to the UniDrive6000. If a UniDrive is not used in a particu-
lar application, the signals from the 100-pin connector must be accessed
individually and routed to appropriate amplifiers, motors, stages, etc. The
terminal block board provides a means of accessing the signals from the
ESP6000 controller card. The terminal block board is shown in Figure 8.1-1.
Table 8-1 — Optional Equipment
CAUTION
Do not force.
Part/Order Number
ESP6000-INTF-BD
22895-01
22897-01
22896-01
22947-01
23657-01
UNIDRIV-BD
UNIDRIVER-RACK
8 - 1