Newport ESP6000 User Manual page 262

C - 1 6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table C.1-5 — Analog Connector Pin-Outs (Continued)
JP2 Pins
18
19
20
21
22
23
24
25
26
+5V, 250mA (maximum)
+5V supply available from the PC.
+12V, 250mA (maximum)
+12V supply available from the PC.
–12V, 250mA (maximum)
–12V supply available from the PC.
Analog Ground
Analog-to-Digital Converter (ADC) signal ground.
Analog Input 0-7
Refer to Section 9, Data Acquisition for information.
Axis-5, 6 Servo DAC Output
The servo Digital-to-Analog converter (DAC) output is the ±10 volt, 18-bit
resolution control signal used control DC servo motors. These signals are
made available on this connector for special applications where the users
need to observe the actual control signal output to the amplifier for
analysis purposes.
Digital Ground
Ground reference used for all digital signals.
E-Stop Interrupt to DSP
This input is normally high. Pulling it low will interrupt the ESP6000
controller card.
Reset Output from DSP
This signal is a buffered active-low signal connected to the ESP6000
controller card reset signal.
Function
Analog Input 0
Analog Input 1
Analog Input 2
Analog Input 3
Analog Input 4
Analog Input 5
Analog Input 6
Analog Input 7
Unused
DB 25 Pins
22
10
23
11
24
12
25
13
-