Direct Connection To The Esp302 Controller - Newport ESP302 Startup Manual

ESP302 Controller
3.7.1

Direct Connection to the ESP302 Controller

For a direct connection between a PC and the ESP302 controller you need to use the
Ethernet cable and either the REMOTE or the HOST connector at the back of the
ESP302.
Figure 15: Direct connection to the ESP302 using Ethernet cable.
REMOTE Connection:
• After connecting the REMOTE connector on the back of the ESP302 to the PC, an
Unidentified network will appear in your active networks found under Control Panel
> Network and Sharing Center.
The REMOTE plug has a DHCP server which automatically assigns an IP address on
the PC's Ethernet card.
Use the following procedure to ensure the Local Area Connection is set to obtain an IP
address automatically.
15
Start-Up Manual
A1270B1 - EDH0411En1021 – 02/20