Fuse Replacement; Replacing Fuses On The Unidrive Rear Power Line Panel - Newport ESP6000 User Manual

B.2

Fuse Replacement

Appendix B — Troubleshooting
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
B.2.1 Replacing Fuses On The UniDrive Rear Power Line Panel
Power-down equipment and unplug AC power cord
At the rear of the UniDrive6000, depress the fuseholder tabs with a small,
thin-bladed screwdriver (see Figure B.2-1) and ease the fuseholder out of
the AC plug receptacle.
Remove and inspect the fuses. Replace as needed with 4A, SLO-BLO, 250V
fuse (Schurter part number 21406-24)
Re-insert into the AC plug receptacle by pushing in the fuseholder until the
tabs snap in place.
POWER ENTRY MODULE PANEL
AXIS
CONTROLLER
6 5 4 3 2
! VOLTAGE
CAUTION:
NO USER SERVICEABLE
PARTS INSIDE. REFER
SERVICING TO QUALIFIED
SERVICE PERSONNEL.
WARNING:
FOR CONTINUED PROTECTION
AGAINST FIRE RISK,
REPLACE ONLY WITH FUSE
OF SPECIFIED RATING.
FUSE
4A, SLO–BLO, 250V
N97107C
Figure B.2-1 — Rear Power Line Panel Fuse Replacement
Re-connect and power-up the system to verify that the problem has been
corrected.
WARNING
before replacing fuses.
POWER
1
SUPPLY
TABS
LINE
SELECT
90-120V OR FUSEHOLDER
200-240V
(SIDEVIEW)
115V
50/60 Hz
MAX 4 AMP
GROUND
POST
FUSEHOLDER
FUSES
TABS
B - 3