Figure 2.4-1 - Enclosure Removal - Newport ESP6000 User Manual

N97115
Figure 2.4-1 — Enclosure Removal
Locate an open PCI card slot in the chassis which is not obscured by
adjacent cards. If other cards are protruding into the PCI slot space, it
may be necessary to re-locate them in order to install the ESP6000 card.
PCI spaces are identifiable by a double-row female edge connector on the
PC motherboard.
Remove the retaining screw(s) on the inside of the cut-out panel for the
PCI card slot, and remove the panel.
Due to varying card guide configurations of computers, it may be neces-
sary to remove the bracket at the end of the ESP6000 card in order to
install the card. Make a visual determination before attempting to con-
tinue installation.
Insert the 100-pin connector edge of the ESP6000 card through the open
panel, and the rear of the card into the card guide at the back of the PCI
card slot.
Orientation for card insertion is shown in Figure 2.4-2.
2 - 6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com