Read Items When Opening Program In Robot Controller - Mitsubishi Electric MELFA FR CR800 Series User Manual

11.2.3. Read Items when opening program in robot controller

You can set the robot program read items divided into command lines, position variables, and program external
position variables. This function is displayed after H1 edition on CRn-500 series controller.
The default values of read items are as follows.
The program external position variable read operations are shown in "Table 11-1 Program External Position
Variable Read Operations". (For details on program external position variables, see "Detailed explanations of
functions and operations" in the robot controller's user's manual.)
Read Item
CR800/
CR750/700
series robot
controllers
This screen is not displayed.
*1: When Movemaster commands are used, all external position variables are read.
*2:
When only P_100 (1) is used in the command statement, P_100 (1) to P_100 (10) are all read. However, the number of
valid elements depends on the robot controller software version used.
11-119
Figure 11-6 Read Items
Table 11-1 Program External Position Variable Read Operations
Position variable, joint variable
(P_01, J_02, etc.)
(MOVEMASTER command :
Reads only the external position
variables (position variables, joint
variables) used in instruction
statements. (*1)
Reads all external position variables (position variables, joint
variables, position array variables, joint array variables).
Reads only the external position
variables (position variables, joint
variables) used in instruction
statements. (*1)
Reads all external position variables (position variables, joint
variables, position array variables, joint array variables).
Reads all external position variables (position variables, joint
variables, position array variables, joint array variables).
901-999)
Reads all elements used in
instruction statements. (*2)
Reads all elements used in
instruction statements. (*2)
Position array variable,
joint array variable
(P_100( ), J_102( ), etc.)
11-119