Table of Contents
Advertisement
13.7.5. PROFINET parameters
This sets the PROFINET information in the robot controller.
Caution
This function can only be used with CR800-D/CR750-D/CRnD-700/CRn-500 series robot controllers.
Set parameters while connected to the robot controller.
Double-click [Field network parameter] -> [PROFINET] under the [Parameter] item to be edited from the project
tree.
After you change a parameter value, you can rewrite the parameters in the robot controller by clicking the [Write]
button.
Figure 13-72 PROFINET parameters
You can reference explanations of the displayed parameters by pressing the [Explain] button.
When the PROFINET IO 2-Port module is mounted, the contents of the option card information are displayed in
"Network base card information". When the module is not mounted, nothing is displayed.
Figure 13-73 PROFINET parameters (Network base card information)
13-258
13-258
Advertisement
Table of Contents
