18.1.12.
Load Data
The data file and log file which were saved in "18.1.11 Save Data/Log Setting" can be displayed on the graph
by clicking the [Load Data] (
18.1.13.
Save Image
Clicking the [Save Image] (
currently displayed can be saved as a bitmap image
The image file name and the image save folder name are as follows.
Item
Image file name
Image save folder
18.1.14.
Gray scale
When the gray scale checkbox is turned on, the graph is displayed in gray scale.
18.1.15.
Reflect to 3D monitor
Clicking the [Reflect to 3D monitor] button () in the [Oscillograph] tab -> [Monitor] group on the ribbon, you can
reflect the joint position (FB) or joint position (CMD) which you acquired from the robot on the 3D monitor.
18-406
) button in the [Oscillograph] tab -> [Data File] group on the ribbon.
) button in the [Oscillograph] tab -> [Data File] group on the ribbon, the graph
Table 18-7 image filename & Image saving folder
Img<time stamp>.bmp
The <time stamp> shows the time stamp when the [Image save] button was
clicked.
Example:
Img20130911-183525.csv
"Workspace \ Project \ Oscillograph \ Image"
Explanation
18-406