Table of Contents
Advertisement
11.9.2. Saving on computer
Saves the program being edited to the computer. At this time, you can set a new program name.
Click the [File] tab -> [Save] group -> [Save As -> PC...] button on the ribbon.
Input the robot program name, and then click the [OK] button.
Caution
Folder in which programs are stored
Programs on the computer are managed in units of workspace projects. The folder they are
stored into is workspace writing folder/project name/Program.
To store into another folder, first store in this folder, then copy to the desired folder with the
program management copy function.
Caution
About program names disabled on PC
A Windows error will occur when the name of a program in the robot controller has same name
as a "reserved word" in Windows. To solve this problem, it is necessary to change the program
name in the robot controller.
The "Reserved words" are special words used by Windows system. Therefore, it is impossible to
use these words as a file name on a PC. The following words are "Reserved words".
AUX, COM1 to 9, CON, LPT1 to 9, NUL, PRN
11-166
Figure 11-62 Saving on Computer
11-166
Advertisement
Table of Contents
