Mitsubishi Electric MELFA FR CR800 Series User Manual page 634

Check item or cause
Do the communications settings in this
software and on the robot controller match?
When Communication Server 2 is yellow (overall)
(6)
When Communication Server 2 is displayed in yellow, check the following.
Check item or cause
Is this software in the "Online" status?
When Communication Server 2 is in light blue or blue (overall)
(7)
If Communications Server 2 is displayed light blue or blue, but communications are still not possible, check
the following.
Check item or cause
Is there a communications error in this
software?
Is a simulation underway?
(Note) Only the standard edition has the
simulation function.
Is the screensaver
computer?
Is the computer's hard disk is power save
mode?
Communication with the robot controller is cut off mid-way through.
(8)
If you cannot communicate with the robot controller, check the following.
Check item or cause
Is the screen saver set, hard disk power off
set, system standby
shut-down set?
Is some other product running that uses
communication?
Or is any permanent resident software
running that uses communication?
27-634
The communications settings in this software and on the
robot controller must match.
The communications settings for this software are made
on the project edit screen. For details, see "9.2
Connection Settings".
For
communications parameters with the optional teaching
box. For details, see "Detailed explanations of
functions and operations" in the robot controller user's
manual.
This software initially starts in the "Offline" status. When
you put it into "Online" status, it communicates with the
robot controller.
For details, see "8.18 Offline/Online/Simulation".
Check the contents of the communications error and
close the communications error window.
End the simulation.
running on the Close the computer's screensaver.
Close computer hard disk power save mode setting.
If any of these functions are running, they may cause a
set, or system communications time-out, so do not use any of these
functions.
A computer communication port cannot be opened for
two applications, so either close the other application or
change the port that this software uses.
Solution
the robot controller
Solution
Solution
Solution
side, change the
27-634