Table of Contents
Advertisement
15.
Maintenance
In maintenance, you can maintain the robot in various ways, including setting origin data and initializing various
information.
15.1. Setting Origin Data
You can save robot origin data to a file, edit it, and transfer it to a robot controller.
Set origin data while connected to the robot controller.
From the project tree, double-click the target project [Online] -> [Maintenance] -> [Origin Data].
Caution
About controller modes in which origin data can be read/written
The controller modes (TEACH/AUTO (Op.)/AUTO (Ext.)) in which origin data can be read/written
depend on the CRn-500 series robot controller version. For details, see "Table 15-1 Origin Data
Reading Robot Control Operation Mode" and "Table 15-2 Origin Data Writing Robot Control
Operation Mode".
15-324
Figure 15-1 Starting up the Origin Data Setting Screen
Figure 15-2 Origin Data Screen
15-324
Advertisement
Table of Contents
