Introduction; Important Messages - SKF Multilog On-Line System IMx-M User Manual

Important Messages

The following messages are important information that require special care in order to
have a safe and reliable IMx-M system.
Important messages, instructions and information in this manual must be
followed carefully. Otherwise, harm might occur to equipment and/or personnel.
IMx-M shall be used for speed alarming only. It shall not be used to protect/trip
machine on overspeed. IMx-M does not fulfill the requirements related to
overspeed protection.
All safety critical decisions must be driven by the data from the protection
module.

Always use relay outputs for the safety/danger triggering.

Use @ptitude Observer only for monitoring purposes.

Use 4-20 mA outputs only for monitoring purposes.

Use Modbus data only for monitoring purposes.
Note: Be sure to always monitor the circuit fault status (circuit fault relay).
In order to ensure a safe system, installation, configuration and maintenance
of the system must be done by trained personnel only.
An IMx-M rack/cabinet contains circuit boards that are static sensitive.
Therefore, appropriate precautions must be used to prevent electrostatic discharge
(ESD) when handling circuit boards, refer Rack/Cabinet.
Each module must be placed correctly in the designated slot. The designated
slot of the each module is shown in
section.
SKF Multilog On-Line System IMx-M
User Manual
Front Panel in Drawings and Connections
1

Introduction

1 - 1