Setting A Frame Delay; Setting A Format Converter - Sony MLS-X1 User Manual

2
Select the target input to set.
To select and set multiple inputs, place a check mark
beside the target inputs to set.
3
Set the [CCR/HDR] switch to the on state.

Setting a Frame Delay

1
Open the Home > Setup > System > Input > Input
Adjust menu (19101.31).
2
Select the target input to set.
To select and set multiple inputs, place a check mark
beside the target inputs to set.
To select and set all inputs, place a check mark in the
Select All checkbox.
3
Set the [Frame Delay] switch to the on state.
To disable a frame delay, set the [Frame Delay]
switch to the off state.
4
Press the button on the right of the [Frame Delay]
switch and enter a delay value (1 to 4 frames) in the
numeric keypad window.
Note
Ancillary data is deleted from signals for inputs
configured with a frame delay.

Setting a Format Converter

You can use a format converter on odd-numbered inputs.
Setting the conversion format
You can set the signal format of an input signal to convert
by the format converter.
Notes
• Field frequency and frame frequency conversion is not
supported.
• Ancillary data is deleted if a conversion format is
configured that is different from the system format.
• When receiving IP signals, adjacent ports may be
affected if the adjacent input ports are in the following
states.
– When a signal is input that is different from the input
format converter setting
– When the input format converter setting is changed
– When one input signal is disconnected while the same
signal source is being input
The following ports are affected, depending on the
signal format of the system.
– 2160P: Affected in units of 2 ports. [1ch-2ch]
[3ch-4ch] ... [143ch-144ch]
– 1080P, 1080i: Affected in units of 4 ports. [1ch-4ch]
[5ch-8ch] ... [157ch-160ch]
The signal formats that can be converted are given below.
System signal format
(frequency)
2160P 2SI
(59.94, 50)
1080P
(59.94, 50)
1080i
(59.94, 50)
1
Open the Home > Setup > System > Input > FC
Format menu (19101.32).
2
Select the target input to set.
To select and set multiple inputs, place a check mark
beside the target inputs to set.
To select and set all inputs, place a check mark in the
Select All checkbox.
3
Press the [FC Format] button and select an input
signal format from the pull-down list.
Adjusting the conversion method
The conversion method adjustment items and the target
conversion formats are given below.
Adjustment item
Up-converter
conversion mode
I/P converter
conversion mode
1
Open the Home > Setup > System > Input > FC
Adjust menu (19101.33).
2
Select the target input to set.
To select and set multiple inputs, place a check mark
beside the target inputs to set.
To select and set all inputs, place a check mark in the
Select All checkbox.
3
Adjust the conversion method.
To set the up-converter conversion mode
Press the [Conversion] button and select a conversion
mode from the pull-down list.
369
Signal format of input
signal
1080i
1080P
2160P 2SI
720P
1080i
1080P
720P
1080i
Conversion format
• 1080i t 2160P
• 1080i t 1080P