YASKAWA Sigma-V Series User Manual page 51

 Converter
CN101
CN103,
CN104
1,
B1, B2
L1, L2, L3
Connectors/
Terminals
L1, L2, L3 Main circuit power input terminals
CN101 Control power input connector
Main circuit DC voltage output ter-
P, N
minals
Ground terminal
Regenerative resistor connection
B1, B2
terminals
1, 2 DC reactor connection terminals
CN103,
Control power output connectors
CN104
Converter
SGDV-COA5EDA
2
Name
Three-phase, 380 to 480 VAC, +10% to -15%, 50/60 Hz
24 VDC, ±15%
Mating connector model: 231-202/026-000 (Manufactured by
Connect these terminals to the P and N terminals on the SERVO-
PACK.
Connect this terminal to the power supply ground terminal and
then ground it.
Connect these terminals to the regenerative resistor unit.
Remove the short bar before you connect a DC reactor.
CN103 and CN104 output 24 VDC to the SERVOPACK.
The 24-VDC (±15%) input is output unaltered from CN103.
CN104 provides the same output, but it is normally not neces-
sary to connect it.
3.1 Main Circuit Wiring
P, N
Specifications
Wago Company of Japan, Ltd)
Pin 2: 24 V
Pin 1: 0 V
3
3-5