Installing An Expansion Card; Concluding Steps - Fujitsu PRIMERGY CX2550 M2 Upgrade And Maintenance Manual

Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section
brackets" on page
6.3.3.3

Installing an expansion card

Ê If applicable, install a slot bracket on the new expansion card as described
in section "Mounting expansion card slot brackets" on page
Ê If applicable, reinstall SFP+ transceiver modules on the new expansion
card, as described in section
page 98.
Ê Install the new expansion card as described in section
to the riser module" on page
Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
overview" on page
6.3.3.4

Concluding steps

Perform the following procedures:
"Installing the riser module" on page 43
Ê
"Installing the server node in the server enclosure" on page 50
Ê
Ê Reconnect all external cables.
"Enabling replaced components in the system BIOS" on page 73
Ê
"Controls and indicators on the server node" on page 51
Ê
"Updating RAID controller firmware" on page 67
Ê
"After replacing / upgrading LAN controllers" on page 83
Ê
"Updating the NIC configuration file in a Linux environment" on page 77
Ê
"Looking up changed MAC / WWN addresses" on page 80
Ê
CX2550 M2
95.
"Installing SFP+ transceiver modules" on
109.
206.
Upgrade and Maintenance Manual
"Mounting expansion card slot
"Mounting a controller
(if applicable)
Expansion cards
95.
"Cabling
(if applicable)
113