Installing An Expansion Card; Preliminary Steps; Removing The Slot Cover (Only Slot 2-4) - Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual

9.5.1

Installing an expansion card

I
After installing an EP5x0i controller with the intention to replace the
Oculink onboard controller, never forget to change the system
information using the Chassis ID Prom Tool.
Upgrade and Repair Unit
(URU)
Tools: slot 1: Phillips PH2 / (+) No. 2 screw driver
slot 2, slot 3, slot 4: tool-less
9.5.1.1

Preliminary steps

"Suspending BitLocker functionality" on page 77
Ê
"Shutting down the server" on page 49
Ê
"Disconnecting the power cord" on page 50
Ê
"Getting access to the component" on page 52
Ê
Ê Remove the corresponding riser module, see section
module" on page
9.5.1.2

Removing the slot cover (only slot 2-4)

Figure 134: Removing the slot cover - example riser module 2
Ê Remove the slot cover.
RX2530 M4
68.
Upgrade and Maintenance Manual
Expansion cards and backup units
Hardware: 10 minutes
Software: 5 minutes
"Removing a riser
221