Service manual Kona cutting plotter
Troubleshooting
N°
Check cutting mat for unevenness and damage. If necessary replace the
7
cutting mat.
Slow down cutting speed.
8
Perform offset calibration.
9
Perform quality tests from Mutoh CutServer.
10
Check parameter JOB FOCUS in user menu. Select ACCURACY instead of
11
SPEED.
Check X&Y belt tensions.
12
Perform Y-Z measurement in diagnostics mode.
13
Check cutting head for play on UP/DOWN bearing.
14
Replace X- and/or Y-motor.
15
Replace mainboard.
16
Replace penhead assembly.
17
124
Possible solution
Link
-
-
-
Mutoh CutServer tests > Tracking test on page 100
-
X drive belt tension on page 86
Y drive belt tension on page 87
YZ profile on page 114
-
X-motor and drive belt on page 33
Y-motor on page 36
Electronics > Mainboard on page 67
Penhead assembly on page 44
AP-74380 - Revision 1.1