Service manual Kona cutting plotter
Part replacement
Step 4:
Step 5:
Reassembling notes
Follow the procedure below to replace the flatcables correctly.
Step 1:
Step 2:
Step 3:
Step 4:
68
Remove the 2 screws fixing the mainboard. (only for machine versions A1 and A2)
Refer to
Machine version on page 24
Push in all studs with a set of pliers, remove the mainboard and replace it.
Be sure that the lip of touchscreen flatcable connector is in the up position.
Insert the flatcable.
Push down the lip of the connector to secure the cable.
Also be sure that the flatcables or mounted rectangularly.
m
AP-74380 - Revision 1.1