3.8
Electronics
3.8.1
Mainboard
Tools necessary
P2 screwdriver
Set of pliers
USB cable
Mutoh CutServer and PC
Replacement procedure
Follow the procedure below to replace the mainboard.
Store the current parameters using the Mutoh CutServer.
Step 1:
Refer to
Remove the following covers first:
Step 2:
Unplug all connectors and flatcables. Note that the touchscreen flatcable has a
Step 3:
special connector. You should push up the lip of the connector before removing it.
AP-74380 - Revision 1.1
Parameters > Backup parameters of machine on page 98
Right cover
Refer to
Cover removal > Side covers on page 28
Front platen
Refer to
Cover removal > Front platen on page 31
Service manual Kona cutting plotter
Part replacement
3
67