MUTOH Kona 760 Service Manual page 133

Service manual Kona cutting plotter
Troubleshooting
Error Message
6225 Possible data clip detected
Print distortion
6226
bad rectangle
Print distortion
6227
print stretch
Print distortion
6228
print stretch
Print distortion
6229
print stretch
133
Description
One or more frame points lie outside hardclip region. Plot
data will be clipped.
Original print distortion. No perfect rectangle, no parallel
sides (difference > 3mm)
Stretch detected on bottom of frame. P1 & P4 have identical
thickness. P2 & P3 have identical thickness. But thickness
of P1-P4 and P2-P3 differ too much from each other. Print
is stretched.
Stretch detected on top of frame. P5 & P8 have identical
thickness. P6 & P7 have identical thickness. But thickness
of P5-P8 and P6-P7 differ too much from each other. Frame
(print result) is stretched.
Stretch detected on side of frame. Px & Py have identical
thickness. Pw & Pz have identical thickness. But thickness
of Px-Py and Pw-Pz differ too much from each other. Frame
(print result) is stretched! Depending on kind of measured
segment: Px, Py, Pw, Pz are different.
1. Px = P1, Py = P4, Pw = P5, Pz = P8
2. Px = P1, Py = P4, Pw = P9, Pz = P10
3. Px = P9, Py = P10, Pw = P11, Pz = P12
4. Px = P11, Py = P12, Pw = P5, Pz = P8
Solution
Outer pressure rollers are inside
frame.
Bad print quality or outside specs.
You can try to cut the job if you want
to. Perfect quality is not
guaranteed. What to check in case
of bad quality:
Printer settings

RIP settings

Design

AP-74380 - Revision 1.1
Category
Warning
Warning
Warning