Vacuum Fans - MUTOH Kona 760 Service Manual

3.8.7

Vacuum fans

Tools necessary
P2 screwdriver

New cutting mat

Replacement procedure
Follow the procedure below to replace the vacuum fans.
Remove the following covers first:
Step 1:



Refer to
Remove the cutting mat.
Step 2:
Refer to
Disconnect the fan cable.
Step 3:
Remove the 4 screws fixing the vacuum fan.
Step 4:
Replace the fan.
Step 5:
Install new cutting mat.
Step 6:
Refer to
Adjustments necessary
After replacing this part, it is necessary to make the following adjustment.
N°
YZ calibration
1
AP-74380 - Revision 1.1
Side covers
Y-rail cover
Rear platen
Cover removal on page 27
Cutting mat on page 66
Cutting mat on page 66
Description
Service manual Kona cutting plotter
Link
YZ measurement on page 93
Part replacement
3
83