Y Drive Belt Tension - MUTOH Kona 760 Service Manual

4.1.2

Y drive belt tension

After replacing the following parts:
Y motor replacement
Y-drive pulley and speed reduction belt
Pressure roller assembly replacement
Adjustment procedure
Follow the procedure below to adjust the tension of the Y-drive belt.
Loosen the 2 screws fixing the Y-motor assembly.
Step 1:
Attach a piece of rope around the motor body as close as possible to the side plate.
Step 2:
Pull the bar tension gauge (range 5kg) perpendicularly for 3.5 kg ± 0.05 kg.
Step 3:
Move the cutting head manually left and right a few times before fixing the motor
Step 4:
screws while holding the tension gauge under a constant pressure of 3.5 kg.
AP-74380 - Revision 1.1
Part
Y-motor on page 36
Y-drive pulley and speed reduction belt on page 38
Pressure roller assembly on page 61
Service manual Kona cutting plotter
Adjustments and calibrations
Link
4
87