MUTOH Kona 760 Service Manual page 132

Service manual Kona cutting plotter
Troubleshooting
Please find below an overview of the codes and category of problem
A warning means that you will have the choice to continue cutting the current segment, all segments or to cancel the job.

An error means that you will have to retry the scanning routine. The reading of the frame has been cancelled.

Error Message
6201 EPOS alignment aborted
6202 EPOS alignment aborted
6203 EPOS alignment aborted
6206 Movement failed
6207 Movement failed
6208 Movement failed
6211 Barcode problem occurred
6212 Barcode problem occurred
6213 Barcode problem occurred
6214 Barcode problem occurred
6215 Barcode problem occurred
6216 Barcode problem occurred
6218 Media size problem
6221 Page problem occurred
6222 Page problem occurred
6223 No EPOS reference found
132
Description
EPOS alignment aborted
The pressure rollers are raised
Alignment procedure has been aborted by the user
Movement failed during EPOS routine (moveabsc)
Movement failed during EPOS routine (drawcontrol)
Movement failed during EPOS routine (scanroutine)
Barcode too long
Barcode width problem
Barcode height problem
Barcode scan problem 1 (lower line of barcode)
Barcode scan problem 2 (upper line of barcode)
Checksum not OK
Check if the margins left, right, top and bottom are within
the specifications.
It might be possible that the file you have sent is not correct
PG after job failed
PG between 2 segments failed or the cutter is set to repeat
mode and there cannot be found a next job.
During search with EPOS laser, no edge was found 
(colour <> white)
Solution
-
-
Rescan the job and if the error still
occurs, try to:
Replot the job

Reprint the job

Did you sent the correct file

Check the media size
-
AP-74380 - Revision 1.1
Category
Error
Error
Error
Error
Error
Error