Adjustments necessary
After replacing this part, it is necessary to make the following adjustment.
N°
Uninstall and reinstall USB drivers on
1
the PC
Load firmware
2
Restore parameters
If there are no parameters available,
either perform the additional
adjustments mentioned below or
contact our service department
3
(service@mutoh.eu)
AP-74380 - Revision 1.1
Description
X - Y distance accuracy
Y - Z measurement
EPOS calibration
Service manual Kona cutting plotter
Part replacement
Link
Software and drivers on page 96
Software and drivers on page 94
Restore parameters of machine on page 99
Mutoh CutServer tests on page 102
Mechanical adjustments on page 93
EPOS calibration on page 103
3
69