MUTOH Kona 760 Service Manual page 43

Reassembling notes
Move the penhead to the far left of the machine and press it against the pen until the
Step 1:
sheet-off knife is pushed out completely.
Mount the flatcable to the penhead PCB and fix the flatcable bracket.
Step 2:
Start guiding the flatcable in the gutter until you reach the middle (where no double
Step 3:
sided tape is installed).
Adjust the flatcable position until it does not interfere with the Y-return pulley
Step 4:
bracket. If you do not install the flatcable correctly, it might be damaged during
cutting.
Guide the flatcable through the cutter to the right side.
Step 5:
Stick the flatcable onto the double side tape.
Step 6:
Bend the flatcable in an angle of 90° and fix the flatcable bracket as shown below:
Step 7:
Plug the flatcable in the mainboard. Be sure the flatcable is installed rectangularly.
Step 8:
AP-74380 - Revision 1.1
Service manual Kona cutting plotter
Part replacement
3
43