MUTOH Kona 760 Service Manual page 101

The following pattern will be cut. Evaluate the test file as follows:
Step 7:
When establishing a deformation to the left or right, check the following things and perform
the test once again. If none of these help, please contact our Mutoh Service Department.
Be sure that you are testing within the conditions summarized in the beginning of the

procedure.
Be sure that the grit rollers are not covered with dirt.

Be sure that the grit rollers are not damaged or worn out.

Be sure that the pressure of the pressure rollers is correct.

Refer to Mechanical adjustments > Pressure roller pressure on page 90
Be sure that the pressure rollers are not damaged or worn out.

Be sure to use all pressure rollers during this test.

AP-74380 - Revision 1.1
Service manual Kona cutting plotter
Adjustments and calibrations
When you see the following pattern
(slight deformation to the left), the
tracking of the machine is not good. See
below for fixing the problem.
The tracking test has been finished
perfectly. All boxes have been cut
exactly on the same line.
When you see the following pattern
(slight deformation to the right), the
tracking of the machine is not good. See
below for fixing the problem.
4
101