X-Motor And Drive Belt - MUTOH Kona 760 Service Manual

3.2

X-motor and drive belt

Tools necessary
P2 screwdriver

Replacement procedure
Follow the procedure below to replace the X-motor and/or drive belt.
Remove the following covers first:
Step 1:



Remove the 2 screws fixing the X-motor assembly.
Step 2:
Disconnect the cable at the front side of the cutter.
Step 3:
AP-74380 - Revision 1.1
Left cover
Refer to Cover removal > Side covers on page 28
Front platen
Refer to Cover removal > Front platen on page 31
Rear platen
Refer to Cover removal > Rear platen on page 32
Service manual Kona cutting plotter
Part replacement
3
33