Ram Errors - MUTOH Kona 760 Service Manual

6.2.6

RAM ERRORS

Signalisation
There will be no error displayed. The cutter will not complete the start-up routine, however,
the error LED (LD3R) on the mainboard will lit RED.
Refer to Electronics > Mainboard > LED summary on page 73
Remove the right cover of the cutter to see the error LEDs.
Refer to Cover removal > Side covers on page 28
Troubleshooting
The mainboard should be replaced
Refer to Electronics > Mainboard on page 67
AP-74380 - Revision 1.1
Service manual Kona cutting plotter
Troubleshooting
6
141